Toggle Nav
My Cart

Pressure Treated Fence Panel 1800mm High

£130.00
In stock
Product code:
Pressure Treated 1800

Our pressure treated panels offer the same great modern and contemporary look as the other slatted screens within our range, but at a much lower cost.

The 1800mm high panels can be made using our narrow or wide pressure treated slats.

44mm x 17mm slats - From £40.00

70mm x 17mm slats - From £45.00

The slats used to make the panels are planed on all four sides, have eased corners to produce a premium look (compared to a square finished corner), has the same 12mm gap between the slats and fixed from the rear to give a clean, fix free finish from the front end of the panel.

The panel is pressure treated to give full protection against rot so can be left to weather naturally or can be stained to brighten up your garden, courtyard or roof terrace.

Simple to handle and install and easily trimmed if required (just add an additional slat to your order for trimming)

Available in 1800mm & 2100mm widths - matching gates also available to complete the look

Please note: The panels can be stained if required although this is not a service that we offer.

Description

Pressure treated slatted fence panels offer a modern and contemporary look to any garden, courtyard or roof terrace, while still allowing natural light to pass through.

Available in both 1800mm & 2100mm wide options.

**Our 1800mm high section comes in three modular pieces, roughly 600mm high each, these simply stack one on top of the other to gain the overall 1800mm finished height, this makes installation very easy compared to dealing with one larger panel. Ideal as a stand-alone fence or screen, perfect for adding height to an existing wall, or for screening existing fencing or walls, that are perhaps, not so pleasant to look at. Our slats are fixed from the rear using stainless steel fixings, so no nails are seen from the front to give a more premium look, the slats used are 44mm wide and have eased corners rather than the standard square finish, again to give a more premium look to the panel, the gap between the slats is 12mm.

Remember to add your capping strip below if required.

A matching capping strip can be added to the top of the panel if required, please add this option to your order below.

Matching Bin stores & Gates are available to complete the look, please see our other listings or feel free to get in touch to discuss further. Bespoke widths, heights and gap sizes can, of course, be made, please contact us with your sizes and we will happily price these for you if needed.

Write Your Own Review
You're reviewing:Pressure Treated Fence Panel 1800mm High